|This is a noise processor which contains two Theremins, Droner, Shaker and Tracer in one package.
|Controls of the Shaker: GAIN, DIST/BOOST switch and LEVEL. The Shaker is a shaking noise generator which makes the sound by shaking the Shaker/Tracer Unit.
|Controls of the Theremin: There are two Theremins and each has LEVEL, FREQ and MUTE switch. Theremin is a music device that controls the pitch with the distance between the antenna and your hand.
|The tape head on the back of the Shaker/Tracer Unit. The Tracer is a magnetic tape reader which outputs the pre-recorded signal on the magnetic tape sheet. Two antennas are an interface for the Theremins to control the pitch.
|The LEVEL control for the Tracer. There is a jack to connect the Shaker/Tracer Unit on the side.
|Controls of the Droner: LEVEL, OSC1 and OSC2. The Droner is a bottom range oscillator which oscillates at a low frequency in the audible range. There are two oscillators in one unit.
|The jacks, from the left: power jack for a DC9V-AC adapter, output jack for the Theremin1, Theremin2, Tracer, Shaker and Droner. Use a mixer to connect all 5 effects at once.
|It can be played using a strap belt like guitar.
|If you play the MNP2 with a strap, you may want to put the SHAKER/TRACER UNIT temporarily. It can be placed into the back of the magnetic tape sheet.
|L:260mm W:145mm H:90mm
|Theremin 1, Theremin 2, Tracer, Shaker, Droner
|Connecting cable for the Shaker/Tracer unit
|AC adapter (DC9V "barrel" type tip negative)